OBSOLETE

LM150QML

SNVS383B – MARCH 2006 – REVISED APRIL 2013

www.ti.com

Figure 13. Regulator with Line Resistance

in Output Lead

With the TO-3 package, it is easy to minimize the resistance from the case to the set resistor, by using two

separate leads to the case. The ground of R2 can be returned near the ground of the load to provide remote

ground sensing and improve load regulation.

PROTECTION DIODES

When external capacitors are used with any IC regulator it is sometimes necessary to add protection diodes to

prevent the capacitors from discharging through low current points into the regulator. Most 10

μF capacitors have

low enough internal series resistance to deliver 20A spikes when shorted. Although the surge is short, there is

enough energy to damage parts of the IC.

When an output capacitor is connected to a regulator and the input is shorted, the output capacitor will discharge

into the output of the regulator. The discharge current depends on the value of the capacitor, the output voltage

is able to sustain 25A surge with no problem. This is not true of other types of positive regulators. For output

capacitors of 25

μF or less, there is no need to use diodes.

The bypass capacitor on the adjustment terminal can discharge through a low current junction. Discharge occurs

when either the input or output is shorted. Internal to the LM150 is a 50

Ω resistor which limits the peak discharge

current. No protection is needed for output voltages of 25V or less and 10

μF capacitance. Figure 14 shows an

LM150 with protection diodes included for use with outputs greater than 25V and high values of output

capacitance.

D1 protects against C1

D2 protects against C2

Figure 14. Regulator with Protection Diodes

8

Submit Documentation Feedback

Copyright © 2006–2013, Texas Instruments Incorporated

Product Folder Links: LM150QML